You are here: Get Started > Stage 1: Setup > EtherLynx Hardware Connections

EtherLynx Hardware Connections

Once the EtherLynx camera is securely mounted, connect the rest of the EtherLynx Hardware.

ClosedWHAT ARE THE MAIN CONNECTIONS?

  1. Connect the female end of Connection Box cable (DB 15) to the port on the back of the camera labeled Connection Box and the male end to the left side of the Connection Box.

  2. Connect an Ethernet cable between the back of the camera labeled POE 10/100/1000 to the port labeled Out on the Power over Ethernet injector.

  3. Connect an Ethernet cable to the network connection on your computer and the other end to a port labeled In on the Power over Ethernet injector.

  4. Connect the male end of the start sensor cable to the Connection Box where it says Start. Attach the start sensor to the other end of the cable and keep the start sensor close by.

  5. Connect the capture button to a 9-pin serial port, or a USB port with the supplied adapter on your computer.

  6. Turn on the camera by pressing and holding the black power button on the back.

NOTE: See the EtherLynx Camera Back Panel diagram.

 

You are here: Get Started > Stage 1: Setup > EtherLynx Hardware Connections